• 12336 Emerson Dr, Brighton, MI 48116

Metal Protect 5000

Metal Protect 5000 – water based, dries clear, suitable on all types of metal. Used indoor ideally.

buy-now-blue

Product Description

Temporary protective peelable masks are used to protect metal parts from corrosion or damage during handling, shipping, and storage. Parts are brushed or sprayed with Metal Protect 5000. When dried, the resilient, air-tight, strippable coating protects the parts until they are needed.

The General Chemical Preservation System peelable maskants are non-toxic, nonflammable and the water borne skin tight film will not damage bare metal or painted surfaces.

Our temporary protective coatings are water borne. It peels away clean leaving no residue. A full range of metal protecting peelable coatings are available to protect ferrous and non-ferrous metals.

We have a solution whether you need temporary protection during in-plant processing, medium-term protection for shipment and storage, or extended protection for lay-up or field service protecting from a variety of environmental conditions. Now you can effectively protect your metals and products against humidity and aggressive atmospheres, as well as against corrosive industrial, marine, and tropical atmospheres.

Protected parts are immediately ready for use when the peelable coating is removed. No degreasing, scraping, cleaning, or further preparation is necessary before processing, installation, or use. Your protected components, parts, and finished assemblies are always ready for immediate use.

Main Advantages

  • Results in a reduction of labor costs.
  • Once cured, it provides tough, corrosion resistant film.
  • Curing time can be cut considerably with the use heat lamps (100F), circulation of air and other factors.
  • Easily removed…peels off in sheets which eliminates messy hand scrapping
  • Safe…non-flammable

Application

Metal Protect is used as received, it can be applied by air or airless spray, roll coating, or brushing. (Use lamb’s wool roller).

Using standard good atomizing spray equipment (e.g. DeVilbiss MBC gun, FF nozzle and No 765 air cap) with pressure feed, a 100 micron (0.004″) film can be applied to a vertical surface in one coat. Atomization pressure of 5ATM (75lbs/sq in) and sufficient pot pressure (0.3 ATM – 5lbs/sq in) to obtain proper fluid delivery is recommended. Airless spray can also be used such as Graco No 205-904 with a 163-168 insert and a 28:1 ratio pump. Use water only for cleaning spray equipment.

Apply product evenly to produce a dry film thickness of approximately 7-10 mils or wet film thickness of 14-20 mils. Drying time is dependent on temperature. At 70°F, product will dry in approximately 24 hours. You can enhance drying time by air movement and other suitable means. Do not apply if temperature is below 45°F.

Warranty: Metal Protect 5000 has shelf life of 1 year from the date of manufacture.  The dried peelable coating should be removed within 1 year.

Operating Guidelines:

  • Using standard good atomizing spray equipment (eg. DeVilbiss MBC gun, FF nozzle and No 765 air cap) with pressure feed, a 100 micron (0.004″) film can be applied to a vertical surface in one coat. Atomization pressure of 5ATM (75lbs/sq in) and sufficient pot pressure (0.3 ATM – 5lbs/sq in) to obtain proper fluid delivery is recommended. Airless spray can also be used such as Graco No 205-904 with a 163-168 insert and a 28:1 ratio pump. Use water only for cleaning spray equipment.
  • Chemical goggles and impervious gloves should be worn when handling.

 

Additional information

Weight 9.00 lbs

Reviews

There are no reviews yet.

Be the first to review “Metal Protect 5000”