• 12336 Emerson Dr, Brighton, MI 48116

Boothcoat 2810

General Chemical's Boothcoat 2810 is a temporary clear peelable coating for paint spray-booth walls, ceilings, floors and other surfaces where paint over spray accumulation must be readily removed. Boothcoat 2810 can be used as a peelable coating on steel surfaces to eliminate flash rusting or as protection on glass, plexiglass, rubber, cement, aluminum and many other hard surfaces.

buy-now-blue

Product Description

General Chemical’s Boothcoat 2810 is a temporary clear peelable coating for paint spray-booth walls, ceilings, floors and other surfaces where paint over spray accumulation must be readily removed. Boothcoat 2810 can be used as a peelable coating on steel surfaces to eliminate flash rusting or as protection on glass, plexiglass, rubber, cement, aluminum and many other hard surfaces.

Application

How To Apply:
Boothcoat 2810 coating when applied improperly can cause problems. Proper application results in a tough film of uniform thickness with no sags, less application time and minimal clean-up labor. General Chemical’s waterborne clear peelable coating may be used wherever temporary protective coatings are needed to reduce cleanup problems. Spray-booths, floors, windows, walls, machinery, equipment and fixtures have all been applications for peelable coatings. If you have an overspray problem, a cleanup problem or an emissions problem, call us.

1. Apply 10-12 mils wet water based peelable film to clean, dry surfaces (booth walls, fixtures) in a smooth, continuous spray. If using airless equipment, use .015 or .017 nozzle at a set pressure of 1200-1500 PSI. With conventional air spray, we recommend Binks nozzle #68PB with needle #368 at a pressure of 35-55 PSI.

2. After significant paint overspray buildup, film may be quickly and easily removed. Cut film to start peeling from one corner. Production time between cleaning is increased; quality control is improved with better illumination.

3. Simply peel off in large, continuous sheets. Booth is left clean and ready for next application. Messy hand scraping or solvent removal eliminated. Clean-up is fast. Waste disposal costs cut.

4. The coating provides a tough, flexible solvent-resistant film which protects booth walls, paint fixtures, metal parts in storage, or any non-porous metal surface from paint overspray.

Boothcoat 2810 is normally used as received. It is applied by airless spray, roller or brush . The sprayed peelable coating air-dries in 10 minutes to 3 hours, depending on thickness of the coating, humidity, temperature and air movement. Boothcoat 2810 is applied to form a film thickness in the range of 2 to 5 mils (.002″ to .005″). The coating is resistant to attack by most paint solvents. Application temperature is ambient to no lower than 60° F. Boothcoat 2810 coating cures upon water evaporation. Improved air movement and temperatures up to 130ºF will cure this coating in as little as ten minutes.
Removal Characteristics of white peelable booth coating : to be removed by peeling it off.