Introduction: Peelable Coatings
The tough General Chemical’s Peelable coating clear film is still the best method of preventing scratches and abrasions and strips cleanly away from the surface leaving no residue. It will also act as a masking against paint overspray.
- Results in a reduction of labor costs.
- Once cured, it provides an extremely tough, uniform film.
- Curing time can be cut considerably with the use of heat lamps (100°F), circulation of air and other factors.
- Easily removed. Peels off in sheets which eliminates messy hand scrapping.
- Safe, non-flammable.
- Suitable for all substrates including polycarbonates, plastic and painted surfaces.
It is critical that Our Peelable coating film is allowed to cure dry. Drying time will vary according to humidity, temperature and weather condition. The evaporation of water will be speeded by air movement and warmth supplied by natural and mechanical means.
It is possible to get a 3 mil tack free dry coating film in less than one hour drying in air at ambient temperature. For maximum tensile strength , 12 hour drying time is better. Blowing air past the surface of the wet film, drying time can be shortened. Heated air up to temperature of 115f can also help in drying time. Mask cures upon water evaporation.
Dry time is dependent upon temperature, humidity, air movement and thickness of the coating. Curing may be accelerated by forced dry air up to 100 degrees Fahrenheit. Force dry coatings can cure in less than 10 minutes. Most coatings without assist will dry in a few hours. It is imperative that Liquid Mask be thoroughly cured and dry, before an attempt is made to peel the coating from the substrate. Cured coating is transparent throughout. Cured Mask is water resistant. Surfaces coated with Mask can be water mopped.
Application by roller might require a few coats. Thick coating peels in one large continuous sheet. Thin coatings will break in areas of coating weakness. Mask is water based for safe use and easy water clean up. Dry coatings are water resistant. When applying Mask use the same protection as used while applying paint.
Our Peelable coatings is a temporary protective Peelable coating and adhesion is low.
Our Peelable coatings once completely dry are resistant to water and solvent and acts as a mask against sprayed emulsion paints, lacquers, oil or grease and water.
The dry Our Peelable coatings strippable coating film can be easily removed either by hand stripping or other means. Our Peelable coatings are thermoplastic. Do not try to remove in freezing conditions. Our Peelable coatings becomes brittle in freezing condition.
Our Peelable coating is a water-based product and you can clean spray equipment and brushes with water. Do this immediately before peelalbe coating starts to dry.
Paint Spray Booth Peelable Coatings
Developed for application to walls and floors of paint spray booths and surrounding area. The peelable masking film protects the walls and floors of the spray booth area from paint overspray and yet maintains its integrity by not allowing solvent penetration. It can be quickly peeled from any surface, even when heavily laden with overspray.
General Chemical’s water based & solvent based fast drying Peelable / Paint spray booth strippable coatings are temporary protective strippable coatings for Spray booths, Paint Booths, industrial floors & various surfaces such as paint booths spray booths, glass, decal, storage parts wood and others to protect it temporarily during industrial process or in material handling.